DeBOND™ biodegradable paint remover in Australia from Marine Energy. DeBOND™ is an advanced biodegradable paint remover effective in the removal of old paint and coatings from steel, concrete, aluminium, masonry, brick, and other alloys.
DeBOND™ is designed to remove paint and coatings on surfaces where abrasive blast cleaning is not an option, such as the restoration of brick, sandstone, or other delicate surfaces. Using DeBond will ensure that the original appearance of the substrate is not damaged in any way. Physical damage which can occur during mechanical blast cleaning is avoided.
|DeBONDT™ is a fully biodegradable product that effectively removes:|
• Latex Paint
• Acrylic Paint
• 2-Part Epoxies
• Alkyd Paint
• General Purpose Paints
• High performance coatings
• Fusion Bonded Epoxies
• 2-Part Urethane Materials
• General Paint Stripping
• Aerospace and industrial paint stripping
• Architectural Facades
• Floor coating removal
• Most sealant removal / stripping
• Refurbishment projects in mines,
petrochemical plants and pulp & paper
• Any removal application where blast
removal is not an option due to
environmental or worker safety concerns
• Fully biodegradable
• Very effective in the removal of multiple
layers of paint
• Will remove most high performance coatings
• Water-based material
• Low odor
• Contains no Methylene Chloride, Caustics
• White in color to assist with coverage
Apply in temperatures above 5°C, warmer temperatures increase efficacy. Surfaces should be free of dust, oils and excess water. Ensure all areas not to be stripped are suitably protected. Good ventilation must be provided in confined areas. Thoroughly mix DeBOND each time prior to use and test a small area first to determine substrate colorfastness.
Application and Dwell Time:
Apply DeBOND using an airless sprayer or HVLP equipment. Do not atomize. Use equipment capable of 2000 psi fitted with chemical resistant packaging. Product can be applied with brush or roller only in small areas, as results will be less consistent. Once applied on surface DO NOT AGGITATE PRODUCT. If removing multiple layers, multiple application and removal of lifted layers may be required. Dwell time will vary due to factors such as type and layer of paint, temperature etc. Most removal times will take between 1 – 6 hours to lift. Some high performance coatings may take up to 48 hours. Do not allow product to dry on surface, reapply more product.
Causes skin and eye burns; flush with water if contact occurs. Causes respiratory tract irritation; use only with proper ventilation. Keep out of reach of children. Use standard safety precautions. Store in a closed container when not in use.
$385.00 AUD: Incl GST
$350.00 AUD: Int'l Buyers
Use DeBOND™ to remove the primer / barrier coat between your antifouling paint and gelcoat or other hull substrate. This product is biodegradable and removes paint without the use of dangerous...