FREE FREIGHT ON PARTS IN AUSTRALIA ON ORDERS OVER $150

DeBond

DeBOND is an advanced biodegradable paint remover effective in the removal of old paint and coatings from steel, concrete, aluminium, masonry, brick, and other alloys.

DeBOND is designed to remove paint and coatings on surfaces where abrasive blast cleaning is not an option, such as the restoration of brick, sandstone, or other delicate surfaces. Using DeBond will ensure that the original appearance of the substrate is not damaged in any way. Physical damage which can occur during mechanical blast cleaning is avoided.

DeBONDT is a fully biodegradable product that effectively removes:
Latex Paint
• Acrylic Paint
• 2-Part Epoxies
• Alkyd Paint
• General Purpose Paints
• High performance coatings
(Aerospace, Industrial)
• Fusion Bonded Epoxies
• 2-Part Urethane Materials
DeBONDcan be used on indoor / outdoor, vertical and horizontal surfaces where paint removal is required. This product is effective is removing multiple layers of paint / coatings, however, multiple product application and removal processes may be required. When using on delicate surfaces, such as brick, test a small area first.

 

Applications: Benefits:
• General Paint Stripping
• Aerospace and industrial paint stripping
• Architectural Facades
• Floor coating removal
• Most sealant removal / stripping
• Refurbishment projects in mines,
petrochemical plants and pulp & paper
mills
• Any removal application where blast
removal is not an option due to
environmental or worker safety concerns
• Fully biodegradable
• Very effective in the removal of multiple
layers of paint
• Will remove most high performance coatings
and systems
• Water-based material
• Low odor
• Contains no Methylene Chloride, Caustics
or NMP
• White in color to assist with coverage
during application

 

REFER TO TECHNICAL DATA SHEET FOR COMPLETE APPLICATION, REMOVAL AND SAFETY INSTRUCTIONS. DO NOT STORE IN METAL CONTAINER OR MIX WITH ANY OTHER MATERIALS / PRODUCTS.

Surface Preparation:

Apply in temperatures above 5°C, warmer temperatures increase efficacy. Surfaces should be free of dust, oils and excess water. Ensure all areas not to be stripped are suitably protected. Good ventilation must be provided in confined areas. Thoroughly mix DeBOND each time prior to use and test a small area first to determine substrate colorfastness.

Application and Dwell Time:

Apply DeBOND using an airless sprayer or HVLP equipment. Do not atomize. Use equipment capable of 2000 psi fitted with chemical resistant packaging. Product can be applied with brush or roller only in small areas, as results will be less consistent. Once applied on surface DO NOT AGGITATE PRODUCT. If removing multiple layers, multiple application and removal of lifted layers may be required. Dwell time will vary due to factors such as type and layer of paint, temperature etc. Most removal times will take between 1 – 6 hours to lift. Some high performance coatings may take up to 48 hours. Do not allow product to dry on surface, reapply more product.

Removal:

Residue can be removed by pressure washer (2500-3000 psi). During the removal process two waste streams are created, liquid waste (composed of used product and wash water) and solid waste (paint chips/material). Liquid waste is inert and biodegradable, solid waste should be collected and disposed of according to local government regulations. For indoor application, use a scraper and squeegee then wet/ dry vacuum system. Do not store removed material in metal containers.

 

Coverage:

80 square feet per US gallon (Based on a 1 application process).

Safety:

Causes skin and eye burns; flush with water if contact occurs. Causes respiratory tract irritation; use only with proper ventilation. Keep out of reach of children. Use standard safety precautions. Store in a closed container when not in use.